How to install a water level control valve?
Thread Content
The float tube of this water level control valve is so short – how can it be installed in the water tank? Could some knowledgeable person explain it? It would be great if a picture could be sent as well
For the float-type hydraulic water level control valve, it seems possible to separate the ball valve from the float-controlled on/off valve and connect them with a pipe in between.
I also think it might be possible to extend something in the middle and introduce it into the water tank, but without any examples I’m not sure if it will work
It’s installed as described on the second floor; when installing, make sure that the float can close the valve when it rises, otherwise it won’t work
There’s no need to worry about this; that float is the switch that controls the water pressure above the valve. When it’s turned on, the pressure is reduced, meaning the main valve opens; when it’s turned off, the pressure increases, meaning the main valve closes.