May I ask about the method of using the pipe bottom elevation in PDMS?
Thread Content
On the pipe tray, many pipes need to have their bottoms aligned with each other. I used position>component>bop/top, but it always aligns the bottom of the pipe with the center line of the target pipe, or with the bottom of the inlet and the top of the outlet of the elbow – it’s not possible to achieve alignment of the bottoms directly. I would like to ask the experts if there are any other quick methods available besides direct measurement.
Please upvote the post. Does anyone here know the exact steps to do this?
BOP onto ID@
There are tools with settings; you can ask someone for one
I asked many people; I guess some design institutes might have their own small programs for this purpose. If it has to be done manually, adjustments can only be made using BOP commands
Use the following command: MOVE D DIST ((AODIAM OF CE - AODIAM OF ID@) / 2) TO ID@