Motor soft foot
Thread Content
Dear experts, how can I check the motor software? What to do if you have weak feet? Thank you:P
Test the motor individually; remove the adjustment shims. Measure the vibration at each corner, or you can use a feeler gauge as well. Or monitor using a spectrum analyzer
May I ask, should this soft-foot check be done before testing the motor individually?
May I ask, should this soft-foot check be done before testing the motor individually?
May I ask, should this soft-foot check be done before testing the motor individually?
According to the mechanical equipment installation procedures, soft feet are part of the shimming setup, and they must be checked and installed properly before the motor is installed
Place the dial indicator on the frame, tighten the foot screws one by one, then loosen them again, and observe the changes in the dial indicator.