Questions about aligning compute instances
Thread Content
This is an example of double-table alignment from a textbook; based on the given conditions, a1
It’s too complicated; I can’t understand it. I need to learn it*.
The center of the motor coupling is definitely lower, as the watch case is fixed to the driven shaft while the hands point towards the motor shaft – there’s no problem with that
The calculated diameter of the coupling should be 90; why is it 120 then? I don’t understand. Please give me some advice.
The calculated diameter of the coupling should be 90; why is it 120 then? I don’t understand. Please give your advice
The distance from the radial pointer to the surface of the coupling is 15 mm; it is likely that it is not in direct contact with the outer circumference of the coupling
A bunch of bookworms – why go to such trouble?