Selection of the installation location for electromagnetic flowmeters

Thread Content

Typically, the protection rating of the sensor housing in electromagnetic flowmeters is IP65. There are several points to consider regarding the requirements for the installation environment. 1. When measuring mixed-phase fluids, select a location that will not cause phase separation ； When measuring two-component liquids (such as additives with a conductivity different from that of the main liquid), avoid installing it downstream where mixing has not yet taken place evenly ； When measuring chemical reaction pipes, it should be installed downstream of the section where the reaction is fully completed ； 2. Try to avoid a negative pressure forming inside the measurement tube ； 3. Choose a location with minimal vibration, especially for integrated instruments ； 4. Avoid having large motors, large transformers, etc., in the vicinity to prevent electromagnetic interference ； 5. Locations where it is easy to implement separate grounding for sensors ； 6. Try to avoid high concentrations of corrosive gases in the surrounding environment ； 7. The ambient temperature ranges from -25/-10 to 50/60°C; for the all-in-one design, the temperature is also limited by electronic components, resulting in a narrower range ； 8. Avoid direct sunlight as much as possible ；