Conveyor belt hole polyurethane repair

Thread Content

The belt of the Seventh Branch of Qinhuangdao Port Co., Ltd. was hit by a heavy object. After careful study and testing by the masters, the problem was finally solved for the Seventh Branch and it also saved a lot of money. Material selection: Spray polyurethane, cast polyurethane, adhesive. See picture belt buckle patch: Patch for penetration holes: 1. Cut off and bevel the damaged belt. 2. Punch the buckle 3. Use an angle grinder to roughen the area to be repaired and use a hair dryer to clean the dust on the surface of the belt. 4. Use cloth-based tape to hold the reverse side of the rubber belt. 5. Apply rubber adhesive. Wait until the adhesive is completely dry. 6. Heat the repair glue in a microwave oven and use it if it feels hot with your hands (recommended temperature is 40-50°C) 7. Apply glue and spray on the belt repair area