6 hot oil pipes are heated by a gas stove and then combined into one main pipe
Thread Content
Why do the temperature readings from the six small tubes all be lower than those from the main tube, with an average difference of 10 degrees?
Are there any other heat sources for the main pipe? The average deviation of the branch pipes is 10°; logically, the instruments should be in good condition, as the probability of all of them being faulty is very low.
Hehe, I’ll supply you with pipes, buddy :handshake
With no other heat sources, 6 small tubes are heated by a gas stove and then combined into a main tube; however, the temperature displayed on the sensor for the main tube is higher than those displayed on the sensors of each of the smaller tubes
The temperature of the main pipe is incorrect; otherwise it wouldn’t make sense, as there would always be some loss