Reboiler distributor
2018-04-16View Original
Thread Content
Who has the drawings or information on the manufacturers of reboiler distributors?Reply #22018-04-22
This depends on one’s own process design.
Related Threads in This Forum
← Previous
- Question regarding the inapplicability of GB24511_2017 stain
- Distance between the steps of a ladder-style tripod support
- Tubes cannot be assembled in this way to save energy - HCBBS
- I would like to ask for advice - HCBBS Forum
- Welding cracks are just that simple; once you understand the
- The maximum allowable operating pressure of pressure vessels
- Weld joint coefficient - HCBBS Forum
- Welding of Hastelloy C276 and stainless steel S30408 - HCBBS
- Why leave three threads after tightening the bolt? - HCBBS F
- Problems encountered with atmospheric pressure equipment - H
Next →
- Aluminum alloy surface treatment processes - HCBBS Forum
- Questions regarding the hydrostatic testing of vertical vess
- If the inspection is carried out by the boiler inspection au
- Which department should I go to for the annual inspection of
- How to set the setting pressure of the spherical tank safety
- Who understands the principle of self-acting control valves
- If standard saddle supports are used, is calculation still n
- Scope of chimney design - HCBBS Forum
- The influence of metal physical properties on the weldabilit
- Questions about the container design chapter? - HCBBS Forum
Translated at 2026-07-21 03:02:01
Original: https://bbs.hcbbs.com/thread-1964291-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.