Device parameters for the analysis and design defense
Thread Content
Now, a presentation drawing for a fatigue testing device is needed, and the requirement for the presentation is that it must include transition sections. Modeling and analysis will be carried out; what’s lacking at present is some support in terms of processes, such as the function of openings and their names, as well as the function of transition sections. For now, the following type of equipment has been used as a reference – the interior of this equipment contains CO and water vapor – but the specific names of the openings and the operating procedures are unknown. I’m seeking help from those who have experience with simple pressure vessel systems subject to alternating loads and that include transition sections.
Just create your own labels, such as 1–exhaust port, 2–backup port, 3–steam inlet, 4–liquid discharge port, 5 (bottom)–sludge discharge port
Thank you, :handshake. I see that their designs don’t include any manholes; it’s impossible for them not to provide such manholes.
It is not necessary to install manholes; process holes can also be used as inspection holes. In fact, there’s no need to worry too much about the effect of takeover; for stress analysis problems, it’s sufficient to have typical types of openings, such as those in end caps, cylinder shells, and conical shells – these elements are enough.
Thank you, :handshake. The assignment states that the process design parameters must be met, but I’ve run into a problem – I can’t find suitable equipment. I was also stunned during the last certification renewal when they asked questions like those about the operation procedures of the equipment.