Small micro-torque vessel
Thread Content
Everyone, I need to design a rectangular pressure vessel with dimensions of 320*260*160. The operating conditions involve alternating positive and negative pressures of 40 kPa. A double-bracing structure has been proposed for the initial design, with a wall thickness of 2 mm. Could anyone give me some suggestions?
What are the units for length, width, and height? It can’t be millimeters, right?
Designed in accordance with NB/T47003.1-2009 \"Steel Welded Atmospheric Pressure Vessels\",
With a working condition of alternating positive and negative pressures at 40 kPa, either stress analysis and fatigue analysis should be conducted, or design shall be carried out using a design pressure that is 5 times the amplitude of the pressure wave.
Is normal pressure sufficient? Elder brother
Why must it be rectangular? With such a small volume, it would be much simpler to use a piece of steel pipe with plates at both ends
Could you give some advice? Is it designed as a pressure vessel at normal pressure?