Fiberglass storage tanks are equipped with side-mounted mixers on their tank walls
Thread Content
As the title suggests, I am planning to manufacture several fiberglass storage tanks in the near future. These tanks will be used to store inorganic acids, which are loaded in batches; when the concentration varies significantly, mixing is necessary. Due to space constraints, there is no place to install a circulation pump, so I am considering installing a side-mounted mixer on the tank wall. I have consulted several manufacturers of fiberglass equipment, but the information I received varied greatly – some said it’s possible to install such a mixer on the tank wall with no problems, while others said it could cause cracks and advised against it; still others outright refused to provide any information and stated that such installation is strictly prohibited. I would appreciate everyone’s opinions. If anyone has experience using this type of setup, please share detailed insights.
Firstly, it is feasible to install a side-entry mixer on the tank wall of fiberglass storage tanks. This approach can avoid the problem of structural deformation in the tank caused by the installation of mixing equipment inside it, and it also helps to save space within the tank. However, when installing a mixer on the tank wall, the following issues need to be considered: 1. Material selection: High-quality, high-strength fiberglass material should be chosen. The quality of fiberglass-reinforced plastic materials provided by different manufacturers can vary, so it is important to choose high-quality materials. 2. Selection of mixer: A mixer that can accommodate the container diameter and the properties of the mixture should be chosen. Generally, it is recommended to choose a mixer made of corrosion-resistant stainless steel to ensure optimal mixing performance and a longer service life. 3. Selection of installation location: The location where the mixer is installed is very important for its mixing efficiency; the best location should be chosen based on specific circumstances. Before installation, the tank wall should be inspected to ensure it can withstand the weight and vibrations of the mixer. 4. Installation method: Installation should be carried out in accordance with standard manufacturing procedures to ensure the quality of installation and the effectiveness of use. If drilling holes in the tank wall is necessary, professional equipment should be used to ensure the quality of the holes as well as their accurate placement. In summary, it is feasible to install a side-entry mixer on the tank wall, but care must be taken to select high-quality fiberglass materials, a mixer suitable for the container’s diameter and the properties of the mixture, the optimal installation location, as well as proper installation procedures. .
Obviously, the strength is insufficient. Manufacturers claiming that it can be installed on the tank wall are complete liars.