Should the load test for the three-effect falling film evaporator be conducted at the manufacturing plant or during installation and commissioning?
Thread Content
For three-effect falling-film evaporators, in accordance with the performance test requirements specified in JB/T20118-2009 section 5.4, a load test is required. Should this load test be carried out at the manufacturing plant or during installation and commissioning? The manufacturing plant doesn’t have the conditions to produce steam, right?
The load test of the three-effect falling-film evaporator is usually carried out at the manufacturer’s facility. The performance tests specified in JB/T20118-2009, including load tests, are primarily aimed at verifying whether the equipment’s performance parameters meet the design requirements and ensuring that it can function properly in actual operation. Although manufacturing plants may not have the conditions necessary to generate steam, they usually use other heat sources or temporary steam supply systems to conduct these tests. If load tests are conducted during installation and commissioning, it may be difficult to accurately simulate the design parameters due to site constraints; therefore, it is generally recommended to carry out these tests during the manufacturing phase. .