Problems with radar level gauges
Thread Content
Radar level gauge for tank areas, bus-type communication. The on-site temperature and pressure points are connected to the radar level gauge, and from there to the cabinet room. It has just been put into use after the tank was cleaned; the liquid level shows the maximum value, the temperature also shows the maximum value, while the pressure is within normal ranges. What could be the reason?
Is it a guided wave radar or what type?
Consider whether installing a short pipe for pouring the liquid will cause interference
The maximum liquid level is likely due to interference at the top; it’s hard to say regarding the maximum temperature. First, check the wiring and measure the resistance of the sensor
I’m a primary school student, learning new things!