CS3000 cannot be used for simulation after installation
Thread Content
The CS3000 cannot be used for simulation after installation; is it a KEYCODE issue? The pop-up shows \"failed to start process\". Installed on a virtual machine. Who has a KEYCODE that can be used for simulation? Could you share it?
Ask the service provider. We also have a CS3000 simulation system, but it cannot be run in practice, mainly because certain initial conditions are not available.
What specific version of operating system do you have? Take a screenshot of your keycode; I’ll check if there’s a simulation license
What specific version of operating system do you have? Take a screenshot of your keycode; I’ll check if there’s a simulation license
What specific version of operating system do you have? Take a screenshot of your keycode; I’ll check if there’s a simulation license
XP SP3; I can’t take screenshots for now – I have to wait until evening. The keycode was copied from another computer that can prevent such things
It’s probably not a problem with the KEY; there’s an issue during the installation process. The installer and the KEY are in different locations. Copy the KEY to a USB drive, rename that drive as Drive A, and then proceed with the installation
Hello, I checked the KEYCODE and indeed no simulation license is installed. Could you send it to me? 1659456972@qq.com
There is a universal authorization on Baidu, with xxx following it; you can give it a try