Are manual valves required in the design, before and after the instruments and valves on the pipeline?
Thread Content
Are manual valves required in the design, before and after the pneumatic valves and flow meters installed on the chemical process pipelines? Why do some pneumatic valves and flow meters in our factory have manual valves at the front and back, while others don’t? Personally, I think it should all be designed in such a way that the advantage is ease of maintenance in the future – there’s no need to empty the contents of the pipes entirely; simply closing the manual valve allows for disassembly and repair. Is there any particular way to phrase it if there’s no design? Can the experienced craftsmen give a more reliable explanation?
The more money, the better. However, flowmeters have requirements regarding straight pipe sections, and it is necessary to consider whether the site can meet these requirements.
Oh, right, there are requirements regarding straight sections; I forgot about that.
In my opinion, process requirements need to be taken into account. If the parameters are important and problems arise, they must be resolved promptly without disrupting production; for this purpose, check valves and bypasses should be installed before and after the relevant components. Sufficient straight pipe sections must also be provided for the flow meters.
Hand valves should be provided to facilitate maintenance; of course, if the instruments require straight pipe sections, valves must be installed after meeting those requirements
Fully equipped, facilitating maintenance, installation, and troubleshooting
There are generally no manual valves before and after the flow meter; in some cases, this is due to the need for a straight pipe section, while in others, a manual valve must be installed for differential pressure measurement to facilitate disconnection for maintenance. Whether to install manual valves before and after the control valve depends entirely on the importance of the valve; if a valve failure does not affect production, such valves can be omitted. Add inlet and outlet valves or add bypass valves