Does anyone know about this position feedback?
Thread Content
As shown in the figure, it has just made contact. I don’t know the principle behind this. How can the two cams below be adjusted as needed?
In your question, LZ, there are no images~~~~~~~~~
1. Determine the direction in which the valve should be opened and closed; when adjusting the switch, the cam must press against the microswitch. 2. When trying to start again, the group of microswitches that is closed will be used as the feedback for the open position, while the other group will be used as the feedback for the closed position.
Please post another image, OP, to facilitate analysis by everyone.
1. Determine the direction in which the valve should be opened and closed; when adjusting the switch, the cam must press against the microswitch. 2. When trying to start again, the group of microswitches that is closed will be used as the feedback for the open position, while the other group will be used as the feedback for the closed position. The reply is very comprehensive