Level float calibration
Thread Content
Dear all, when using the water calibration method to adjust the position of the float, the density difference is not significant (0.95, 0.86), and despite multiple attempts the adjustment still doesn’t work – is there any solution?
It is recommended to phrase the question more clearly so that it is easier to identify the issue
The density difference should be within the measurable range of the float; if it is too small, it may not be possible to measure it.
Can I see you spraying everywhere you go? Where are you a sales representative for? Which area?
If the density difference is small, it is best to remove it and calibrate it using weights (professional calibration personnel are required). Calibration is carried out using weights of different masses based on the density of the respective media
There’s no need to pay attention to him; in this vast world, there are all kinds of people
It’s definitely due to an incorrect verification method; it is recommended to read the device manual carefully
The image below shows the verification method; if this method is correct, it is recommended that you have a test conducted to determine the density of the two media, and then use the measured densities for verification. If I’ve done everything as instructed and it still doesn’t work, then it’s a hardware issue; check the troubleshooting guide