Siemens positioner

2019-05-03View Original

Thread Content

When the Siemens positioner is not activated, it displays -12; when the opening degree is 20, it shows 20, and the same applies for 50. It’s not allowed when the value is 0, and it gets stuck at step 4 or step 5 during self-tuning. . Excuse me, expert, what’s going on! ! !

Reply #22019-05-03

The fault in the lower left corner! The on-site locator cannot be set to manual mode. .

Reply #32019-05-04

Could it be that 0-20MA and 4-20MA have been swapped?

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

Siemens positioner

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links