Use PROII for tower design and calculation
Thread Content
Does anyone have examples of PROII tower size design and calculation? Please share them. It’s about calculating some parameters for the tower diameter and height.
If you have specific towers in mind, you can discuss them with Ke Fu Kai; their technical team is quite strong and has extensive experience in using ProII.
Tower diameter calculation and design are built-in; check the help documentation.
Export to KGTower
PROII can be used for the SIZING and RATING of tower diameters. Regarding tower height, generally, the actual number of plates is first determined based on the theoretical number of plates; then, the height of the pure tray section is determined based on the actual plate spacing. Additionally, the transition zone (if there is a change in diameter), the space at the top of the tower, the space at the bottom of the tower (based on residence time), and the space for the feed section are taken into account to determine the total tower height. For SIZING and RATING calculations of towers using PROII, refer to the figure below