Horizontal measurement for tray installation
Thread Content
This post was last edited by mountain16 on 2021-4-30 at 16:24. I saw in the forum that testing is done using transparent rubber U-tubes with scales on both sides; are there any pictures of such U-tubes? I’ve never used this type of testing method; before, I always used a level for inspections
The simplest method is to use a transparent water pipe, attach a section of an old steel tape measure with clear markings to each end, fill it with water in advance, and then use it to measure the level of the tray inside the tower.
Water can’t be filled to the brim, right? Also, is it necessary to wrap the tape around both ends of the water pipe? When measuring, you check whether the water level is at the same height, right?
There’s no need to go through such trouble; using tools like a level is much more intuitive and convenient