Can Q235B flat steel be used for pressure vessels, namely for vessel shells and heads?
Thread Content
Technical exchange: Can Q235B flat steel be used in pressure vessels? Cylinder heads, etc. What is the basis?
Agree with what was said above. One more thing: when purchasing, ask what the maximum negative deviation of the flat panel is, so you know the figure
The question is too vague – what kind of pressure vessel, what is the pressure level, what is the medium, etc. The specific conditions need to be specified first. But then again, it’s a material that’s almost been phased out in pressure vessel applications; what’s the point of using it? It doesn’t save that much money either
Is it because there isn’t enough material on site, so a substitute is needed?