Air source triple unit
Thread Content
The plastic connector on the oil reservoir of the air source trio always cracks and causes air leakage; can it be repaired?
This one should only be replaceable with a new one.
The plastic connector on the oil reservoir of the air source trio always cracks and causes air leakage; it’s better not to try to repair it – just replace it with a more expensive one
The plastic part is cracked; in my opinion, there’s no need to repair it – it’s better to replace it with a new one. In fact, it would be necessary to determine the cause of the crack: whether it’s due to a problem with the product quality or environmental factors.
If it needs repair, you can try using plastic adhesive, but it’s still better to replace it in the end.
The quality is too poor; there are issues with the wiring structure. Add a short tube and a connector
There are cheaper alternatives available on the market
Replace it; that thing isn’t worth anything – production is what matters.
We checked the site to see if anything was causing collisions; we replaced the three-piece assembly three times a week. It was only later that we realized it was the hydraulic vehicle used by the operators to move the tanks that was causing the collisions, and the problem was resolved after adjusting its position
It makes no sense for it to keep cracking; the reasons need to be carefully analyzed, otherwise this problem is likely to occur even with more expensive replacements
It makes no sense for it to keep cracking; the reasons need to be carefully analyzed, otherwise this problem is likely to occur even with more expensive replacements