How do I label the height of a rectangular prism in an axonometric view? Thank you!
Thread Content
How do I label the height of a rectangular prism in an axonometric view? Thank you!
This post was last edited by ylb913 on 2015-10-30 08:21; the markings on the front side show that the leads at both ends are horizontal. Indicated on the side; the lead wires at both ends are angled.
Assuming the upper left corner of the drawing indicates north, the height markings should be aligned with the north-south or east-west direction. In other words, when adding annotations in CAD, the “Isometric Snap” mode is used for annotation. It forms an angle of 60 degrees or 120 degrees with the conventional horizontal and vertical labeling pattern. Select the mode: “Tools->Draft Settings->Snap Type->Isometric Snap”.
First, label it linearly, and then apply the tilting operation.