How are belt conveyor belts glued and manufactured?

Thread Content

To ensure the service life of the conveyor entrance, the belt conveyor is designed so that the interface does not tear when the track deviates; the entrance is made convex depending on the direction in which the belt moves. The key to production is that, after calculating the quantities, any excess rubber and fabric layers can be removed. When in control, the amount of force applied and the depth of the stroke must be well controlled. The key step is pasting, correcting the mismatched areas, and then joining the surfaces. The purpose of polishing is to remove excess rubber to achieve a better bonding effect. The increase in roughness is reflected in changes in adhesion strength. Each belt conveyor needs to be kept clean. Adhesives are generally available in buckets, where they are mixed with a curing agent to form a paste. The relationship between the thickness of the adhesive layer and its shear strength is constantly changing; the likelihood of bubble formation and poor workmanship is low. However, if the adhesive layer is too thin, adhesion issues may arise, and uneven application can also reduce the bonding strength. Therefore, when applying it for production, it is better to keep the layer thin as long as there is no lack of adhesive. In winter, the temperatures are low and evaporation is slow, requiring a longer drying time; if necessary, heating can be used to facilitate better utilization and thus speed up the work process. When connecting, make sure that the center lines of both ends of the belt are on the same straight line and aligned, to avoid repeated adjustments due to incorrect positioning. It is best to use a fixing tool and release it after the adhesive has cured, as this will yield a better bonding result.