Main fan lubrication oil issue
Thread Content
For the 2MCL527 main fan, an electronic pressure, temperature, and flow sensor is installed on each oil pipe before the oil reaches the compressor. What parameters are used to adjust the settings of this device?
There are requirements for the amount of oil to be injected during design; as for pressure, it is necessary to ensure that oil can be injected – if the pressure is too low, the individual oil injector needs to be replaced. As for temperature, it’s not clear!
These operating procedures specify everything; there’s no need to calculate it manually.
Press manufacturers design their systems with specific oil volumes and pressures for each oil supply point; there’s no need for you to request these values from them.