HTRI failed to run
Thread Content
Hello everyone, I’m a newcomer to HTRI. After installing HTRI on my new computer, I entered the data and ran it, but it showed a failure message. Opening the previously saved design file and running it again also results in a failure message; I’m not sure what the reason is
UNIT ID 100: FATAL MESSAGES – CALCULATIONS ABORTED; RUN FAILED; SECURITY ISSUE DETECTED
Yours is the PJ version, right? Redo it using PJ as required; just follow the instructions carefully. SECURITY FAILED means the PJ failed
It seems the cracking was not successful; you need to check whether there is an appropriate executable file in the directory where the files were installed. If not, go and download the cracking file right away.