Which specification specifies the installation dimensions for T-type pipe filters?
Thread Content
May I ask in which specification can I find the dimensions of butt-welded T-type filters at 1.6 MPa and 2.5 MPa? In SH/T3411, the appendix only lists flanged T-type filters with PN2.0 and PN5.0 ratings; so where can one find the dimensions for butt-welded T-type filters with PN1.6 and 2.5 MPa ratings? Since there is no size specified in SH/T3411, does that mean this grade of filter does not exist? Thank you all, haha.
The standards starting with SH do not include pressure ranges with decimals; therefore, there are no corresponding sizes, and the sizes can only be referenced using 2.0 MPa
The size of a T-type filter is essentially the length of the tee + flange + flange cover; for custom filters, we prepare the drawings based on this dimension
In other words, it is possible to purchase the PN1.6 butt-welded T-type filter model, but the specific dimensions for SHT3411 are not provided, right?
What about in the case of butt welding? Just the length of a butt-welded tee?
GB/T 14382-2008 Three-way filter for pipelines
Received, thank you very much. By the way, which standard filters do people usually use?
Received, thank you very much. By the way, which standard filters do people usually use?
Received, thank you very much. By the way, which standard filters do people usually use?
What I’m referring to is butt welding; the flange refers to the part used for removing the filter element at the end