Abnormality in the ball valve of the pneumatic cut-off valve
Thread Content
Pneumatic cut-off valve, ball valve. It responds quickly when turned on. There are 2 problems when turning it off. 1. After the shutdown signal is given, it takes 4 seconds before it takes action. 2. The process from the start of the valve closing action to complete closure is very slow, taking about 5 seconds. The medium in motion are solid particles. Could you please tell me how to solve these 2 problems?
It is best to discuss this with the valve manufacturer
First, it is necessary to determine whether the issue lies with the actuator or the valve; if possible, try separating the actuator from the valve and test it； This can occur if there is internal leakage in the actuator ； This situation can also occur if there is sticking inside the valve; however, it is not possible to go into detail due to the lack of knowledge about the internal structure of the valve.
The main issue is that the valves are sticking; you can contact me as I have solutions.
If it is a pneumatic control valve, 1. The spring force of the actuator is insufficient； 2. The actuator is leaking air; 3. There is a leak in the air supply pipeline. Please check them
I’d like to learn more about your manufacturing process. Could you add me on QQ? I’m unable to add you
I’d like to learn more about your manufacturing process. Could you add me on QQ? I’m unable to add you