[Process Engineering Division – Pipeline and Valve Technology Exchange Forum – Daily Question – Questions 02–09]
Thread Content
This post was last edited by Yunmu on 2019-2-9 20:28 in [Process Engineering Section – Pipeline and Valve Technology Exchange Forum – Daily Question – Questions 02-09]. What are the common pipe fittings used in water supply pipelines? Just name three. Reference answers: tees (equal/different diameters), crosses, reducers, pipe clamps, elbows (45°, 90°), flanges, etc
This post was last edited by Yunmu on 2019-2-9 20:28: tees (equal/different diameters), crosses, reducers, pipe clamps, elbows (45°, 90°), flanges, etc
Elbows (equal/different diameters), tees, reducers, pipe clamps, bends (45°, 90°), flanges, etc
Pipe caps, welding bosses, reducing tees, equal-diameter tees
Elbow, tee, flange, reducer
Elbow, tee, valve
Elbows (equal/different diameters), tees, reducers, pipe clamps, bends (45°, 90°), flanges, etc
Elbows (equal/different diameters), tees, reducers, pipe clamps, bends (45°, 90°), flanges, etc
Metal pipes, plastic pipes, composite pipes
Tees, flanges, elbows, reducers, etc