How to design pipe racks?
Thread Content
Four pipes are used for circulating water: two are of the 80-mm diameter type, and the other two are of the 100-mm diameter type. The height of these pipes is approximately 6 meters. One end of each pipe can make use of the existing cable tray, while the other end requires a custom design. I would appreciate it if someone could give me some guidance on how to carry out this design; the more detailed the information, the better. Thank you!
There is no fixed pattern for pipe racks; it is necessary to analyze each case on its own
1. Both the existing parts and the newly designed parts must meet the span requirements. 2. Review the original pipe rack loads. 3. The support type for the newly designed pipe rack is determined based on the site conditions.
It’s all too professional; is there any experience factor involved? It’s just a single section of pipe – surely there’s no need to turn to a design institute?
I couldn’t understand your design intent at all. Do you want to use the existing truss as a gate frame?