Applications of metal flexible hoses
Thread Content
There is a pipeline in the project that carries material from the reactor to the centrifuge; it is 8 meters long in total. The design team specified the use of an 8-meter-long flexible metal hose for connecting these components. I think this is completely unnecessary, as the purpose of using hoses is to prevent leaks in the pipes caused by the vibrations of the centrifuge. Therefore, I propose installing rigid pipes near the centrifuge, with short-distance metal hoses used for connection. Guru, do you think it’s appropriate?
It should be like this; there’s no need for an 8-meter-long metal hose. One could consult the design institute to find out whether such a design is reasonable
It can be considered to use a metal hose that isn’t so long; your reasoning is valid. With our centrifuges, we don’t encounter metal hoses of such length either – only a flexible connection at the point where it connects to the centrifuge. The design chosen by the design institute likely has its own reasons as well
It can be considered to use a metal hose that isn’t so long; your reasoning is valid. With our centrifuges, we don’t encounter metal hoses of such length either – only a flexible connection at the point where it connects to the centrifuge. The design chosen by the design institute likely has its own reasons as well
I also tend to agree with the original poster. There is absolutely no need to use such a long hose.
Well, I’ll communicate with the design institute again to strive for cost-effectiveness and convenience.
Yes, generally, except for the hoses used to connect to tank trucks and those that are used temporarily and are longer, the rest are all 1.2 meters long
This post was last edited by guohaoran on 2019-8-21 at 21:48. The longer the hose, the greater the pressure fluctuations. To reduce the impact of the hose on the medium pressure, the length of the hose should be minimized at all times.
Will we have the chance to talk about centrifuges later?