Please help, the compressor’s inner cylinder needs to be removed
Thread Content
One of the compressors in our factory has an internal cylinder that cannot be removed; it is likely due to scaling inside. The hydrogen gas returning from the molecular sieve isn’t properly filtered and contains dust. After two days of effort, only 5 centimeters were removed. Does anyone have any good suggestions? Thank you
No tooling? This equipment isn’t something to be taken lightly – the bottom surface of the inner cylinder has rollers; it shouldn’t be this difficult to remove!
It hasn’t been taken apart in 6 years; presumably, there’s severe scaling
Use special tools to extract the rotor, and the cylinder can be heated with a heating strip.