May I ask, where can I find the temperature value of the turbine cylinder?
Thread Content
May I ask, where can I find the temperature value of the turbine cylinder?
There should be several TT and TE sensors on the cylinder block; these are used to measure the temperature inside and on the surface of the cylinder block. The readings can be viewed on both the dashboard and in the control room. By checking the PID diagram of the turbine, it should be possible to locate them
At the site, there should only be the exhaust temperature (usually at the low-pressure end of the turbine); other temperatures can only be viewed in the control room.
It depends on the specific model. Generally, small generator sets are only equipped with an exhaust temperature sensor. Larger units (such as those over 20MW) are equipped with temperature displays for the upper and lower cylinders, available both locally and on the central DCS system. There are also relatively few temperature settings for the upper and lower cylinders of the driven unit.
It’s available on the on-site dashboard; housing temperature