Welding joint
2018-01-13View Original
Thread Content
Question: Welding joint diagram for the half-pipe of a semi-pipe jacketRelated Threads in This Forum
← Previous
- Weld 304 steel plates onto the equipment cylinder of 14Cr1Mo
- Implementation of welding material standards such as 5293-20
- Lu’an Huaji successfully installed all 3 \"Jinhua furnaces\"
- Increase steam pressure - HCBBS Forum
- What are the requirements for valve supply? - HCBBS Forum
- Pressure testing sequence for lined containers - HCBBS Forum
- Why are control valves not suitable for operation at low ope
- What is grade “0” oil-free compressed air? - HCBBS Forum
- Corrosion of nickel alloys in a hydrogen environment - HCBBS
- Two questions about ear-type supports - HCBBS Forum
Next →
- Seeking detailed test procedure sheets for voltage withstand
- I found this thing in the cooling tower pool; I don’t know w
- What is the load-bearing capacity of a 100,000 cubic meter e
- Issues regarding the installation of metal expansion joints
- Are there any special requirements for the installation of f
- Installation and selection of flame arrestors - HCBBS Forum
- Welding procedure qualification - HCBBS Forum
- Some questions regarding the production and filling permits
- Local corrosion and welding failure of the ceiling plate in
- To which department should the annual comprehensive report o
Translated at 2026-07-21 03:05:07
Original: https://bbs.hcbbs.com/thread-1899099-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.