What is the standby state of a filter?
Thread Content
1. After the filter is cleaned, ensure airtightness, perform purging, and verify that the oxygen content is within acceptable limits; then close the valves at both ends and keep the system under nitrogen atmosphere； 2. After the filter has been cleaned, perform a gas-tight purge to ensure that the oxygen content is within acceptable levels. Slightly open either the front valve or the back valve to allow the liquid inside to be discharged; then close both valves completely, keeping the material in the spare filter in a stationary state ； Let’s discuss which one is the correct standby state ? ? ?
Neither is wrong. It depends on the properties of your material: if it’s not prone to deterioration and no chemical changes are likely to occur, then the first method works. However, if such issues exist, then the second method is necessary
This should be based on actual needs; if the gas is of the type meant to be used immediately, it is necessary to prevent pressure buildup from affecting its usable time when it is needed. The same principle applies in the case of liquids as well; for example, a filter in a lubricant station is used for quick switching during emergencies, so it needs to be filled with liquid. The second scenario is more suitable for on-site needs. If there is no such need, complete stillness is the best option. For reference.
Depending on the operational requirements, it is important to know exactly what is being done and what medium is flowing through