Seek E+H electromagnetic flowmeter HART menu
Thread Content
As title: Seeking the HART menu for the E+H electromagnetic flowmeter. Also, which parameters need to be reset after replacing the main board? Thank you all
This post was last edited by tiger2010 on 2019-2-23 09:42. The old motherboard can no longer communicate? If communication is possible, save the old one, then connect the newly installed one and send directly
The old one doesn’t work anymore; is there any solution?
Then just re-enter the sensor parameters according to the standard steps (those on the sensor’s nameplate). That’s how it is with Rosemount sensors; I’ve never encountered a situation where the main board of an E+H electromagnetic flowmeter was damaged. The key is to follow the procedures outlined in the user manual specific to your model
It’s all about directly adjusting the settings via buttons.