Probe settings for combustible and toxic gas detection alarms
Thread Content
The placement of probes is determined based on the factory’s size and structure, with points being selected and positions fixed according to the coverage radius. After installation, it was found that the distance and position between the probe and the release source were incorrect. How can this situation be rectified?
How to make corrections? Let me think........................ Go poop, wash your hands, shut up and turn your head away :lol
The first thing to consider when designing is the location of the source of emission; if adjustments are needed, the only option is to move the probe’s position
Our company specializes in the production of various gas detection alarms, and we have all the necessary certifications. Feel free to message me if needed. . .
Generally, it’s not worth getting too serious about this; the source identified may not be correct
Have the design institute issue a design change, and then reinstall it according to that change
Installed underground, with the probe 30 cm above the ground; on the surface, it is 1.5 m above the ground