Step-by-step guide to maintaining centrifugal pumps
Thread Content
Step-by-step guide to maintaining centrifugal pumps: 40
View it on a computer; it can be seen on the computer
A very detailed tutorial video: lol
Currently, videos can only be viewed on a computer~
? ? ? ? ? Is this to repair a pump? ? Just remove the bearing cover, wipe it clean, and reinstall it? Is the clearance between the bearing and the gland not being measured? Are neither the seal compression nor the shaft end runout measured? Install it on the pump casing without putting the large cover in place first? How can alignment be achieved if even the couplings aren’t rotating synchronously?
This post was last edited by Xiuxi Xi, who specializes in pump repair, on 2020-3-26 at 22:11. Thank you to the original poster for sharing this information; however, there are a few points that everyone should keep in mind: 1. When lifting the pump body, it is strictly forbidden to place your hands on the surface of the coupling, as this can easily lead to injuries. 2. When installing the coupling, it is absolutely not allowed to use a hammer to strike its surface, inner hole, outer circumference, or the bolt holes
Well, it allows viewers to identify many problems, and that’s where the value of this video lies.