Gear pump inlet and outlet
Thread Content
Does anyone know where this hydraulic gear oil pump 532 inlet and outlet flange joint can be produced? Thank you very much.
These two parts should be standard parts. You can go to Alibaba to consult the manufacturer for more direct information!
It shouldn't be a standard part. It's very simple, surveying, mapping and reprocessing. You can also directly find a small processing factory to do it.
I have all these, I just want to find a manufacturer that can produce them
Alibaba is all cast together.
This post was last edited by CHANGBAISHI on 2020-6-5 08:01. This can only be solved by the equipment manufacturer. Because it is a casting, environmental management is very strict now, and no one will produce this small part. If it is cast in one piece, is it possible to cut off a section and tap the inner hole? Or mapping the connection hole, machining one is also feasible. Or get a steel plate and connect it to a stamped elbow. You might as well give it a try.