In Caesar II software, how do you enter the values to represent large pipes supporting smaller pipes?
Thread Content
In Caesar II software, how do I enter ‘(’ to represent a large pipe supporting a small pipe?
As a supplementary note, in the same piping system, the steam pipe with a diameter of DN300 located below serves to support the steam condensate pipe with a diameter of DN80. The stress analysis software uses the CONDE connection method; when two pipes are connected in this way, they end up overlapping. What’s going on? How can I separate them? I tried using the displacement method, but it didn’t work either
Use CNODE to create a rigid connection
Why not take a screenshot and take a look? . .
Similar to the method using false pipe supports, it is connected using CNODE
Firstly, it is not highly recommended to use branch pipes; if branch pipes must be used, use rigid components along with master and slave points