【Daily Question】January 18, 2016: Allowable stress for austenitic stainless steel (first 60 replies + 2 points; additional 3–8 points for correct answers)...

Thread Content

This post was last edited by humanrzm on 2016-1-19 at 09:27. In order to increase the popularity of the heat exchange section, a \"Question of the Day\" activity has been introduced there; this helps to foster active technical exchanges while also providing members with certain financial rewards. 【Daily Question】 True or False: Austenitic stainless steels have two sets of allowable stresses: one set is suitable for applications where a slight amount of permanent deformation is permissible, while the other set is suitable for flanges or other applications where even a minor degree of deformation could lead to leakage or failure. ( )Answer: Correct; for details, see Note 1 in Table 5 of GB150.2-2011. Note: We will close this thread after 24 hours to release the answer and explanation, as well as the best response (the best assistance provided). Other content: AC version of heat exchange equipment – “One question per day” competition (prizes for participation; valid indefinitely) http://bbs.hcbbs.com/thread-1320941-1-1.html. The selection process for active users and “Weekly Stars” in the “Mechanical Section” has begun http://bbs.hcbbs.com/thread-1489069-1-1.html. Recruitment for moderators and technicians in the [Mechanical Section] – applications and referrals are welcome. [Valid indefinitely] – Come if you’re interested! 】http://bbs.hcbbs.com/thread-1288857-1-1.html【Mechanical Section】In-depth guide to preventing equipment from freezing over the winter http://bbs.hcbbs.com/thread-1502793-1-1.html It’s here; we’ve finally waited for it 【Mechanical Section】Thanksgiving sharing event http://bbs.hcbbs.com/thread-1533152-1-1.html