Will pressing the straight edges of an elliptical head increase its thickness? How to handle it?
Thread Content
1. Will pressing the straight edges of an elliptical head increase its thickness? 2. How should clause 6.3.4 in GB/T25198-2010 be understood? 3. Will the thickened part be trimmed off during edge finishing? 4. Is it only possible to measure it, or are there empirical values? I hope someone experienced can give some advice. Thank you!
It will thicken. . . You can choose to use the inner diameter as a reference; if it’s a container, this increase in thickness has little impact. . If it’s a pipe, this thickening has an impact. . Moreover, many pipes are molded using molds, with the outer diameter serving as the reference. . We all need the inner diameter of the cylinder. .
Thickening will occur, but what can be done about the thickening of the head? It doesn’t have much of an impact anyway!