The sulfur melting system generates a lot of dust; how to deal with it?
Thread Content
The sulfur melting system generates a lot of dust, and the odor it produces is strong inside the factory; the sulfur smell can also be detected outside the factory as well. There is considerable pressure related to environmental protection
Add induced draft fans and washing equipment.
Make a mini kinetic wave washer
The resistance of the mini washer will increase, right?
During the melting process of sulfur, the dust generation is much higher than during unloading and when sulfur enters the melting tank; the key dust control points in the sulfur melting system are located at each sulfur feeding port. Using nozzles with good atomization effects, along with automatic control of the water spraying, will yield excellent results. It is the sulfur vapor generated by the sulfur melting system that is difficult to manage, requiring frequent maintenance, cleaning, and repairs.
Spraying water? This will only result in a sulfur smell everywhere in the sulfur melting tank and the factory building.
It refers to the unloading system, which has a good atomization effect; a small amount of water spray is sufficient to reduce dust, and there is no significant increase in the sulfur smell caused by the water spray.
I understand what you mean, but this water will eventually evaporate along with the sulfur vapor from the melting trough, which will increase the sulfur smell in the sulfur melting trough and the entire facility
In fact, it is sufficient to add a washing tower to the containment system and install an exhaust fan at the top of the tower to vent air into the atmosphere