Gauge calibration
Thread Content
What are the main pressure gauges at natural gas stations that require mandatory calibration? Are those on pressure pipelines counted as well, in addition to those on the pressure vessel itself? For Class A pressure gauges that are subject to on-site mandatory inspection, the calibration cycle is currently half a year; for Class B pressure gauges recorded in the instrument register, the calibration cycle is also half a year ； Is there any difference in the calibration of these two types of tables? Are the inspection procedures followed the same? The testing institutions we send our samples to are different, and I just can’t figure out what the differences between them are Please explain. Additionally, the gauge pressure gauges built into some equipment, or the very small gauges used for natural gas, are difficult to remove. Do such gauges need to be calibrated? Can it be classified as Category C and not subject to inspection?
Regarding pressure gauges that are subject to mandatory inspection for safety purposes, I believe it is possible to determine whether such gauges fall under the category of those requiring mandatory inspection by referring to the classification of pressure vessels and pressure pipelines as stipulated in the Regulations on the Management of Special Equipment. Pressure gauges that are subject to mandatory inspection must be tested by testing institutions qualified to carry out such inspections, in accordance with the relevant testing procedures. For Category B devices (used in areas such as process control, quality assurance, and energy management), the calibration cycle can be determined reasonably based on actual usage, and they should be sent to a qualified calibration or testing institution for calibration or testing. For pressure gauges that have modest data requirements and are used only for indication purposes, they can be classified as Category C and require only a one-time calibration or verification, such as the instrument air pressure gauges built into the equipment mentioned by the original poster, or those that are difficult to remove.
1. Determine the calibration cycle reasonably based on actual usage conditions. What are the requirements for this cycle, and what are the criteria used to set it? Is it once a year? Two years? 2.C-class management: It is difficult to disassemble. Can small meters without a root valve be exempted from the initial inspection? For on-site comparison, are there any requirements?
1. The determination of this inspection cycle can be based on an analysis of the operating environmental conditions, the frequency of use, and the stability of the results from previous inspection cycles. 2. As for instruments that are calibrated once, they are generally calibrated before being put into use, and no further calibration is required after installation and operation.
Baidu’s \"Management Measures for the Classification of Measuring Instruments in the Chemical Industry\" – take a close look and you’ll understand