Who are the manufacturers of nitrogen compressor air pipe fittings from Ingersoll Rand?
Thread Content
I want to replace the original hose with a copper one, so I need to reconfigure the connectors. I only know that it’s an imported connector, of British standard. Thank you so much!
This needs to be measured; just give this connector to the machinist.
This post was last edited by Fire Dance_MY8cj on 2020-8-18 at 10:01. These are called cartridge connectors; they are available in hardware stores and come as ready-made products, so no custom ordering is necessary. They are available in both American and British standards. After purchasing them, you simply disassemble them to use – remove the nut and the cartridge in the middle; these two parts are exactly what you need.
Reply to Floor 2 and Floor 3: If I keep the original nuts and only replace the clamps on the hose, will there be leaks?
If the original nut supports self-sealing, then it’s possible