Centrifugal pump pressure gauge
Thread Content
A regular pressure gauge is installed at the outlet of the centrifugal pump in the absorption tower; since lime slurry needs to be added to the tank frequently, the pressure gauge at the pump outlet often gets clogged. Is there any good solution for this?
A backwash water with sufficient pressure can be used.
The pressure gauge at the pump outlet often gets clogged; use a pressure gauge equipped with an isolation fluid
It is recommended to use a diaphragm-type vibration-resistant pressure gauge, the type with flange connections.
Oh, is the cost much higher than that of ordinary ones?
Diaphragm pressure gauges with flange connections necessarily have high prices
Diaphragm pressure gauges with flange connections necessarily have high prices
Those with isolation fluid are better; it’s ideal to have backwashing as well
Without a doubt, diaphragm pressure gauge.