Maximum flow rate in the calculation sheet for the differential pressure orifice flow meter, and the rated flow value?
Thread Content
Simple question: for a differential pressure orifice flow meter, does the upper limit value of the differential pressure correspond to the maximum flow rate specified in the calculation documents, or to the rated flow rate? Hope for a solution! ! !
This can be calculated by inputting the relevant parameters.
The upper differential pressure value corresponds to the rated flow rate in the calculation manual!
It should be the differential pressure at full scale flow.
It should usually correspond to the full-scale flow rate; specifically, it depends on the calculation documents.
The upper differential pressure value corresponds to the maximum flow rate in the calculation manual.
No problem. I just checked the calculation sheet, and it shows the corresponding maximum flow rate