Can this explosion-proof junction box be waterproof?
Thread Content
I see that this type is used for installing lighting fixtures, but won’t water get in through the pipe connections?
Pipe joints can be sealed with tape to prevent water from entering.
With an explosion-proof mud plug, it should still work~~~
Is the shell waterproof? Do I need to add mortar to dig it? I don’t understand what mortar is. What if there’s no clay? What should we do? Can we just use urine to seal it up? :lol
For explosion protection, plastic connectors should be replaced with explosion-proof flexible hoses.
If you install it indoors, there is no need for waterproofing； However, if there is an outdoor conduit for wiring, a hydrophobic connector should be installed at the point where this conduit enters the junction box ； If you install it outdoors, it’s best to equip each interface with a hydrophobic connector ； Ensuring a good seal is just the basics; the intensity of respiration is beyond your imagination!
Check what the IP address shows
It depends on the level of protection required. Typically, explosion-proof components are used for connections in such environments; protection against rain is possible, but protection against water immersion is not feasible, unless proper sealing is implemented
Many explosion-proof junction boxes are not waterproof