After the sulfur paste is produced, what process does everyone go through to melt it in the sulfur melting tank? ? How to handle it later
Thread Content
This post was last edited by liaifeng on 2018-7-29 at 15:49. After being produced, the sulfur paste is conveyed via a belt conveyor to the sulfur melting tank for melting; how can we prevent sulfur paste from scattering on the ground along the belt conveyor? ?
Is considering adding baffles on both sides of the conveyor belt to reduce the drop rate?
There are scrapers at both ends, and over time debris still accumulates
Hey, there’s a baffle, but stuff still accumulates below it
This post was last edited by Gao Yunguan on 2018-9-20 08:46. Using an intermittent sulfur melting furnace is troublesome – the work site gets too dirty. It is recommended to replace the internal fractional sulfur melting tank, and use a pump to directly feed the sulfur foam (sulfur slurry) into the sulfur melting tank.