English — Forum #647 (Page 26/34)
- Sudden increase in liquid level in the cyclic hydrogen desulfurization tower - HCBBS Forum
- The main tower has high moisture content and high pressure at the top, resulting in reduced production capacity. How to deal with this? - HCBBS Forum
- Please tell me how to specify the gasification rate in the PROii mid-tower design regulations. - HCBBS Forum
- If the inert gas content in the ammonia entering the tower changes, how does the ammonia exiting the tower change as a result? - HCBBS Forum
- MDEA concentration in the acidic water at the top reflux of the solvent regeneration tower. - HCBBS Forum
- Solutions for the EAccessViolation error that occurs during the calculation of SW6 column - HCBBS Forum
- Process design for a primary distillation tower for methanol production of 100,000 tons per year - HCBBS Forum
- During the catalytic shutdown, the catalyst enters the inside of the fractionator – how should the catalyst inside be dealt with? - HCBBS Forum
- Key points for modeling and analysis of the tower in CAESAR II - HCBBS Forum
- Basic roadmap for tower design - HCBBS Forum
- Can tower equipment made of 2.5mm stainless steel sheet withstand acidic materials at high temperatures of 400°C? - HCBBS Forum
- Can the absorption stabilization system enable pressure reduction operations in the desorption tower? - HCBBS Forum
- Introduction to the structural principles of packed towers - HCBBS Forum
- What is the typical pressure drop range for towers? - HCBBS Forum
- Common problems and solutions for high-tower compound fertilizers - HCBBS Forum
- Fine argon column - HCBBS Forum
- Tower equipment accessories - HCBBS Forum
- Dust removal measures for urea granulation towers? - HCBBS Forum
- Can carbon steel insulation rings be used for stainless steel tower equipment? - HCBBS Forum
- Selection of the level gauge for the saponification tower bottom liquid - HCBBS Forum
- distillation tower - HCBBS Forum
- Fluctuations in differential pressure in the dry gas desulfurization tower - HCBBS Forum
- PSA—Method for eliminating space in the CO2 tower - HCBBS Forum
- Diagnostic methods for difficult convergence of distillation columns in Aspen HYSYS - HCBBS Forum
- Difference between primary flow tower and flash tower - HCBBS Forum
- Vortex prevention device for absorption tower - HCBBS Forum
- Graphite absorption tower for hydrogen chloride gas absorption - HCBBS Forum
- Pressure control in the diesel hydrogenation unit, stabilizer tower - HCBBS Forum
- The downcomer of the tower is blocked - HCBBS Forum
- Tray pressure difference - HCBBS Forum
- Analysis of the reason why reflux cannot enter the column during the startup of the vacuum distillation tower as shown in the figure - HCBBS Forum
- Two-phase system in extraction distillation column - HCBBS Forum
- Control method for the heating load of a distillation tower - HCBBS Forum
- Regarding how to determine the minimum liquid volume for a plate tower - HCBBS Forum
- Regarding the dehydration operation in the vacuum distillation tower - HCBBS Forum
- Solutions for HYSYS distillation column not converging, with an indication of two liquid phases in certain column sections - HCBBS Forum
- Key operating points for the stabilizer tower - HCBBS Forum
- Reason why the waste alkali in the neutralization tower turns red - HCBBS Forum
- Energy-saving technology for cooling tower turbines - HCBBS Forum
- HG/T21543 Atlas of circular tower platforms, applicable for a minimum tower diameter of 800 - HCBBS Forum
- The impact of the MTBE catalytic distillation column on acid consumption in the alkylation unit - HCBBS Forum
- Relationship between the top temperature of the distillation column and reflux - HCBBS Forum
- Foam tank level in coking desulfurization regeneration tower - HCBBS Forum
- What are the three materials referred to in a urea synthesis tower? - HCBBS Forum
- Coke tower preheating - HCBBS Forum
- Why is the catalytic stabilizer top cooler located below the reflux drum? - HCBBS Forum
- The coal pyrolysis project at Shenmu Ningtiao Tower in Longcheng, Henan. - HCBBS Forum
- Liquid level in the bottom of the distillation tower - HCBBS Forum
- What are the factors that affect the absorption efficiency of the absorber in a stable absorption system? - HCBBS Forum
- What is the flow velocity of normal gas evaporation inside an intermittent distillation column? - HCBBS Forum
- Distillation column simulation - HCBBS Forum
- Dear experts, how are fractional distillation towers and distillation towers defined? What’s the difference? Are all columns for gas phases distillation columns? - HCBBS Forum
- The impact of increasing the liquid level in the lower column on distillation operations - HCBBS Forum
- Requirements and specifications for lighthouse lighting in tank farms - HCBBS Forum
- Reasons for the high bottom temperature in the hydrogen sulfide concentration tower of low-temperature methanol washing - HCBBS Forum
- \"Original essays by people from Haichuan – Thoughts on a visit to the Kumtag Desert\" - HCBBS Forum
- The stabilizer tower is experiencing large fluctuations; I need advice from experienced professionals! - HCBBS Forum
- Medusa – The Beauty of Immortality - HCBBS Forum
- Can four distillation towers share one 50 kPa vacuum system? Is it still one tower and one vacuum pump? - HCBBS Forum
- What parameters are needed for the civil works of designing a tower? - HCBBS Forum
- Operation of the benzene column in the extraction system - HCBBS Forum
- C4 depropanization tower top product - HCBBS Forum
- Looking for CAD drawings of the parts for a packed tower? - HCBBS Forum
- How to inspect static equipment (scrubbers, alkali tanks) - HCBBS Forum
- Manufacturer of tower internals design and fabrication - HCBBS Forum
- How is the setting pressure for the safety valve of the synthesis tower drum determined? - HCBBS Forum
- The vacuum level in the bottom of the vacuum distillation column is higher than that at the top of the column - HCBBS Forum
- Stripping tower - HCBBS Forum
- Sharing of engineering achievements by WPTR software users – 50 kt/a food-grade CO2 purification tower, structured packing tower - HCBBS Forum
- Why does the main inlet valve of the ammonia synthesis tower need a mechanical limit? - HCBBS Forum
- The distillation tower thermal bypass is used in conjunction with the choke - HCBBS Forum
- At what pressure level must the operating pressure of the initial distillation tower be increased to consider it as a pressure-boosting operation? - HCBBS Forum
- 2016 actual exam question: Determine the minimum vapor lift in the tower bottom vessel - HCBBS Forum
- Why, when it’s cold, does the argon tower experience some fluctuations in the morning? - HCBBS Forum
- In the following process, the lower the temperature at the top of the vacuum tower, the lower the vacuum degree at the top, is that correct? Why? - HCBBS Forum
- Distillation column top temperature - HCBBS Forum
- internal recirculation tower - HCBBS Forum
- The bottom boundary of the extraction column shows no stratification - HCBBS Forum
- Tower operating pressure - HCBBS Forum
- Reduced-pressure backflow filter - HCBBS Forum
- An update from the air separation industry, dated 20170615: Seven countries break ties with Qatar; turmoil in China’s helium market - HCBBS Forum
- What are the effects of replacing the original packing tower in the urea decompression tower with trays? - HCBBS Forum
- Anti-corrosion treatment for the inner wall of catalytic desulfurization and denitration towers - HCBBS Forum
- Schematic diagram of the Cassali reactor - HCBBS Forum
- Water stripping tower of extraction unit - HCBBS Forum
- Why is the use of activated carbon tower waste gas treatment equipment on the decline? - HCBBS Forum
- Bapu cooling tower - HCBBS Forum
- 84- The feather leaf separator is used in the design of the inlet gas separator, outlet gas separator, and exhaust gas separator of the MDEA absorption tower in LNG projects - HCBBS Forum
- Could that expert please share the process flow diagram from the outlet of the vaporization furnace to the outlet of the scrubber tower? - HCBBS Forum
- 93- Feather leaf separation inlet separation assembly and precision separation internals for the LNG project’s MDEA absorber outlet separator and MRC buffer tank - HCBBS Forum
- Where is the sensitivity point of the water separation tower in low-temperature methanol washing? What are the phenomena at high and low levels? - HCBBS Forum
- Aspen simulated cooling tower - HCBBS Forum
- Several term explanations for distillation columns - HCBBS Forum
- Question: Dear seniors, I would like to ask why falling film absorbers are generally used in industry to absorb HCl exhaust gases - HCBBS Forum
- The temperature at the top of the tower cannot be reduced, and the temperature at the bottom of the tower cannot be increased - HCBBS Forum
- Control of MDEA desulfurization regeneration loop temperature - HCBBS Forum
- What are the reasons why the temperature drop at the bottom of the regeneration tower cannot be reduced? - HCBBS Forum
- Problem of air cooling blockage at the top of the regeneration tower - HCBBS Forum
- I’m a beginner building a partitioned tower for the first time, and everything shows as red. Here are the issues; please help, experts - HCBBS Forum
- During the installation of the tower internals, it was found that the hole spacing of the welded components inside the tower was quite large - HCBBS Forum